Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
O
PERATION
The number of panels connected to ports 2, 3, and/or 4 may only be equal to or less
than the number set to port 1.
For example: If there are 10 rows and 10 columns (100 total panels), port 1 can be
set from 25–40. If port 1 is set to 40, port 2 will output to 40 panels, and port 3 will
output to the remaining panels, which is 20 (40+40+20 = 100). If port 1 is set to 25, all
ports will output to 25 panels (25+25+25+25 = 100).
Port 1 will not be able to be set to any number lower than 25 because that is the
lowest number that will allow port 4 to be equal to or less than port 1.
These numbers assume the default settings are available, and not overridden by the
firmware of connected panels.
Example Configuration
The following demonstrates how to set the Screen Settings for a video panel configuration with
1 VIP Drive 43Nova and 120 video panels that are 128x128 pixels.
1.
Set the
Cabinet Row Quantity
2.
Set the to
Cabinet Column Quantity
3.
Set the
Port 1 Cabinet Quantity
4.
Set the
Data Flow
by one, all the way to the left, and down by one before repeating.
5.
Connect the panels as in the diagram below:
MAP Function
The <MAP> button not only instantly accesses the Screen Settings menu, but it also toggles the MAP
function. When the <MAP> button is illuminated, all panels connected to the VIP Drive 43Nova will display
their Port number (Port:1–4) and panel number (#01–#_ _).
VIP Drive 43Nova User Manual Rev. 3
to 8.
to 15.
to 30. This will allow each port to output to 2 complete rows.
to the icon below, which will start at the top left, go all the way to the right, down
As Viewed From the Back
Port 1
Port 2
Port 3
Port 4
14
Publicité
Table des Matières
