Bosch GCM12SD Consignes De Fonctionnement/Sécurité page 9

BM 2610007877 04-10:BM 2610007877 04-10.qxp 4/26/10 8:13 AM Page 9
Getting To Know Your Miter Saw
NOTE: To view items 21 through 31, see page 8.
21. Base Extension Clamping levers – Lock the
base extensions at the desired positions.
22. Sliding Base Extensions – Provide extra work
support. Useful when cutting long workpieces.
23. Rubber Deflector – Attaches to bottom of chute.
Deflects dust into the chute.
24. Dust Chute – Directs sawdust up and through the
elbow and to the bag.
25. Elbow – Connects the dust chute to the dust bag.
Can be rotated to direct dust.
26. Dust Bag – Has a zipper at the bottom. Bag can
be uncoupled from elbow for emptying.
27. Mechanism lock lever – Holds saw in full back
position for chop cuts or fully extended for
transporting.
28. link Knob – Attaches guard link to the pivot post.
29. lower Guard link – Allows for smooth movement
of the lower guard.
30. Clamp – Use to hold the workpiece to the table
and base – insert into clamp post location
(item 39).
31. Brush Cap – Keeps motor brushes in position.
Provides access for inspecting and replacing
brushes.
32. Depth Stop Screw – Turn the knob end to adjust
the blade depth for cutting grooves.
33. Depth Stop plate – Plate can be swung out to
limit the depth of the blade travel.
7
42
33
43
41 40
9.
1
34. pivot post – Provides support for the saw head,
dust collection system and other functional parts.
35. Axial Glide Mechanism – Allows saw to smoothly
slide in and out. Can be locked in full rear or fully
extended positions.
36. Bevel Scale and pointers – Scale is large and
angled - allows user to easily read bevel angles.
Pointer indicates what the current angle is.
37. Bevel post – Provides rotating support for all
miter saw parts above the table.
38. Bevel Detent pin (Crown Molding Setting) –
When engaged, it locks the head assembly to the
bevel angle of 33.9° to the left or right.
39. Clamp post locations – Two vertical post holes in
the base – provided to insert the clamp (item 30).
40. Miter Detent plate Screws – Four screws
accessible through holes in the miter scale. These
screws are loosened when adjusting position of
the detent plate.
41. Bevel Range Selector Knob – Allows selection of
3 bevel ranges: "0-45° Left", "0-45° Right" or "Max.
Bevel Angle to 47°."
42. Arbor lock – Press arbor lock button to keep
blade from rotating when loosening or tightening
arbor bolt during blade removal or installation.
43. Head Assembly lock pin – Used to lock the
head assembly in the lower position for
transporting.
44. Glide Movement Controller – Adjusts to regulate
movement of the glide mechanism.
44
(not shown)
32
34
35
36
37
38
39
(not shown)