Bosch GCM12SD Consignes De Fonctionnement/Sécurité page 14

BM 2610007877 04-10:BM 2610007877 04-10.qxp 4/26/10 8:13 AM Page 14
WARNING
source before
adjustments or repairs.
Installing 12" Blade
WARNING
diameter and 1" arbor. The blade's maximum
plate thickness is 0.100".
WARNING
greater.
1. Follow all "Moving Guard Assembly" and "Remov-
ing Blade" steps.
2. Carefully handle the new blade. Check that the
rotation arrow on the blade matches the rotation
arrow on the lower guard. Slide the blade up and
between the sides of the chip deflector and over
the arbor shaft. Move the blade so its arbor hole
goes around the support ring of the inner washer
(see Figures 4 and 5).
3. Place the outer washer over the arbor shaft and
finger-tighten the blade bolt (counterclockwise).
Check that the blade remained on the inner
washer's support ring.
4. Rotate the blade slowly while pressing the arbor
lock until it fully seats into its lock position.
5. Using the 6/4mm hex key, firmly tighten the blade
bolt counterclockwise. NOTE: This bolt has left-
hand threads. Do not over tighten. A 6mm hex key
may be used as an alternate.
6. Remove the lower guard link from the rear cover
plate screw. Rotate the lower guard and cover
plate around the front cover plate screw until the
cover plate's slot slides under the rear cover plate
screw head. Fully tighten both cover plate screws
using the 6/4mm hex key.
7. Place the lower guard link back to the original po-
sition, then firmly finger-tighten the link knob to the
pivot post. It may be necessary to retract the lower
guard while tightening the link knob.
8. Be sure the arbor lock is released so the blade
turns freely.
9. Place the 6/4mm hex key back in storage area.
Removing and Installing Blades
To avoid possible
disconnect plug from power
performing any assembly,
To avoid injury, do not use a
blade larger or smaller than 12"
To reduce risk of injury, use saw
blade rated 3800/min (RPM) or
ssembly
injury,
WARNING
interfere with and hang up lower blade guard.
Never use saw without cover plate securely in
place. lower guard will not function properly.
WARNING
interfere with the table insert at 0° and 45° bevel
positions. lower the blade into the blade slot and
check for any contact with the base or turntable
structure. If the blade contacts base or table,
seek authorized service.
Outer Washer
Blade Bolt
figure 5. Blade Hardware
14.
Tighten the cover plate screws.
loose cover plate screws may
After installing a new blade,
make sure the blade does not
Saw Blade
Inner Washer
Arbor Shaft
Support Ring