Brandt BFC3854NX Guide D'installation Et D'utilisation page 30

EN 3. INSTALLING YOUR NEW APPLIANCE
16. Connect electrical connector
dance with step 3 and then install part
(which is in the plastic bag).
17. Reverse part by 180°and install it onto
the right corner of upper door, then
mount part . (both of which are taken
down in step 2)
18. Take the reed switch out of the coping
block(part 6 in step 3) and mount it on
another block for use (which is with mark
"R" in the plastic bag). Put the coping
block just removed back to the plastic
bag.
Note: Be sure character side of reed
switch fi ts well with coping block.
19. Install part
tor
20. Open the upper door, mount door racks
and then close it.
in accor-
30
connect the wire connec-
, and then install part .