Brandt BFC3854NX Guide D'installation Et D'utilisation page 28

EN 3. INSTALLING YOUR NEW APPLIANCE
2. Open part on top of the refrigerator
body from right side and then take down
part and part
the same way. Take down part
it back to the plastic bag.
3. Disconnect electrical connector as well
as electrical connector and then take
down part .
4. Remove the screws
remove par .
on the upper door in
and put
, loose wire , and
Note: Please hold the upper door by hand
during step 4 to prevent door dropping.
5. Remove the upper door and place it
on a smooth surface with its panel
upwards. Lever part and part
loose screws
Change handle
install screws , part
Loose screws , detach part
then install part
the plastic bag)to the left side with
screws .Put part
plastic bag.
6. Loose screws used to fi x the middle hinge
and remove middle hinge. Then remove
the lower door.
7. Place the lower door on a smooth surface
with its panel upwards.
Change the handle to the right side accor-
ding to step 5. Loose screws , detach
part and part .Turn part
then install part
ponding position on left side together with
screws .
28
then
, as shown in the picture.
to the right side, then
and part in turn.
and part
and another part (in
just detached back to
by 180°and
and part to corres-