Brandt BFC3854NX Guide D'installation Et D'utilisation page 29

3. INSTALLING YOUR NEW APPLIANCE
8. Change screw hole covers on middle
cover plate from left to right (as shown in
fi gure below).
9. Place refrigerator fl atwise, remove part
and then loose screws
and part .
10. Screw out lower hinge, change it to the
near hole site, and then screw up and
mount washer.
11. 11.Just remount to the step 9,change
part to left and part
fi x them with screws . Finally install
part .
. Remove part
to right and then
29
12. Move the lower door and adjust its posi-
tion to align lower hole site and upper
hinge axis. Turn the middle hinge by 180,
change the washer on the axis to the
upper side, adjust the middle hinge to the
appropriate position and then install it.
13. Screw out The upper hinge axis, turn the
upper hinge over and fi x axis on it. Then
place it at side for use.
14. Exchange wires both in the left and right
slots of refrigerator body
15. Move the upper door to appropriate posi-
tion, adjust part
the connecting wire
door from right to left, and then fi x part
and wire by screws .
(Please hold upper door by hand when
installing)
EN
and upper door, Move
in the slot of upper