Charcoal Embers; Glowing Embers; Battery Back-Up Installation - Napoleon B36NTR Instructions D'installation Et D'opération

56
6.5

CHARCOAL EMBERS

EN
CHARCOAL EMBERS, VERMICULITE AND CHARCOAL LUMPS ARE NOT TO BE PLACED ON THE
Randomly place the charcoal embers along the front and sides of the log support tray in a realistic manner.
Fine dust found in the bottom of the bag should not be used.
NOTE: Charcoal embers are not to be placed on the burner.
6.6

GLOWING EMBERS

Tear the embers into pieces and place along the front row of ports covering all of the burner area in front of
the small logs. Care should be taken to shred the embers into thin, small irregular pieces as only the exposed
edges of the fibre hairs will glow. The ember material will only glow when exposed to direct flame;
however, care should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. PHAZER
logs glow when exposed to direct flame. Use only certified "glowing embers" and PHAZER
from your authorized dealer / distributor.
6.7

BATTERY BACK-UP INSTALLATION

ENSURE THE GAS AND ELECTRICAL POWER TO THE APPLIANCE IS TURNED OFF.
APPLIANCE MAY BE HOT, DO NOT SERVICE UNTIL THE APPLIANCE HAS COOLED.
NOTE: In the event of a power failure your appliance can be operated using the battery back-up supplied.
Before beginning installation, disconnect the gas and electrical power supply from the appliance.
A.
Locate the battery housing supplied in the manual baggie.
B.
Install four "AA" batteries (not supplied) into the battery housing, ensure the positive and negative
C.
ends correspond with those identified on the holder. (To open the battery housing, slide the back
piece upwards and off of the battery housing).
Remove the safety screen to easily access the control compartment.
D.
Attach the wire labelled "BATTERY"
E.
from the wiring harness, located in the
control compartment of the appliance,
to the battery housing.
Place the battery housing into the
F.
control compartment, ensure that the
battery housing is placed in a clean
and easily accessible location.
G. Reinstall the safety screen. The safety
screen must be installed at all times
during the appliance operation.
Turn the gas and electrical power back
H.
on to begin operating the appliance.
NOTE: Once the power has been restored,
remove the batteries from the holder. The
system will drain the batteries if they are left
in the battery holder.
W415-1678 / B / 03.27.17
WARNING
!
BURNER.
WARNING
!
Control module
Red wire
Black wire
Battery housing
32.1
TM
logs available
TM