Front Hood Installation; Side View - Napoleon B36NTR Instructions D'installation Et D'opération

Leave a hand on the glass door during entire door
removal. The glass door is secured to the firebox with two
spring latches along the top and two along the bottom.
Pull the handles of the latches forward, then lift the latches
out from the door frame to release the top of the door.
Repeat the same step for the two bottom latches. Next,
pivot the door forward until the top edge clears the front of
the appliance. Carefully grip the sides of the door lifting it
off the appliance. NOTE: These spring latches make up
the spring relief system for the appliance. Ensure they
open freely and close sealed.
Reverse these steps to reinstall the safety screen and
door. Ensure safety screen is installed correctly.
6.2

FRONT HOOD INSTALLATION

NOTE: This hood MUST be installed, if it has not already been factory installed.
Safety door and screen must be removed.
A.
Remove the securing screws from the top of the firebox, as shown.
B.
C. Install the front hood, ensure it is angled downward when installed.
Reinstall the previously removed securing screws.
D.
HOOD

SIDE VIEW

Spring Latches Spring
Latches
53
EN
X5
W415-1678 / B / 03.27.17