24
3.13
TOP EXIT
EN
FAILURE TO CREATE A SEAL TO THE FIREBOX WITH THE EXHAUST COLLAR ASSEMBLY WILL CAUSE
THE APPLIANCE TO FUNCTION IMPROPERLY AND CAN CAUSE INJURY OR PROPERTY DAMAGE.
NOTE: This appliance has been factory shipped as a rear vent.
Remove the safety screen and glass door, refer to " SAFETY SCREEN & DOOR REMOVAL /
A.
INSTALLATION" section.
Remove the contents from the firebox and set aside,
B.
you will need the exhaust and air inlet collars.
To ease assembly, remove the four hex head screws
C.
securing the deflector from inside the top front of the
firebox, refer to Figure 1.
Remove the outer coverplate and gasket by removing the four screws. Install the outer coverplate and
D.
gasket onto the back of the appliance using the four previously removed screws, refer to Figure 2.
Remove and discard the 1 1/2" (38.1mm) thick batt of insulation and discard, refer to Figure 2.
E.
Remove the four screws securing the inner coverplate, 'o' ring and gasket, remove the inner cover
F.
plate and discard, refer to Figure 2.
Reinstall the 'o' ring and gasket into the appliance using the previously removed screws, refer to Figure 2.
G.
Place the 7" (177.8mm) intake collar and gasket onto the top of the appliance and secure using
H.
four screws. (TIP: The gasket and screws are supplied in the manual baggie; the screws are
seperately packaged in their own bag).
From inside the firebox, install the 4" (101.6mm) exhaust collar, with gasket, up through the top of
I.
the firebox and secure with the the four hex head 3/4" black screws supplied in the manual baggie.
NOTE: Do not overtighten. The gasket needs only to be snug against the firebox.
Install the glowing embers and charcoal embers, refer to the "GLOWING EMBERS" AND "CHARCOAL
J.
EMBERS" sections for detailled installation instructions.
OUTER
Reinstall the top deflector, log set, glass door and safety screen.
K.
COVERPLATE
GASKET
FIG. 2
'O' RING
OUTER
COVERPLATE
INNER
COVERPLATE
GASKET
GASKET
'O' RING
1 1/2" GASKET
INNER
COVERPLATE
GASKET
1 1/2" GASKET
W415-1678 / B / 03.27.17
WARNING
!
FIG. 3
OUTER
COVERPLATE
GASKET
OUTER
COVERPLATE
GASKET
FIG. 1
DEFLECTOR
DÉFLECTEUR
EXHAUST
FLUE COLLAR
EXHAUST
FLUE COLLAR