Nice One OXI Série Instructions Et Avertissements Pour L'installation Et L'utilisation page 4

2 – FUNCTIONAL PRODUCT
EN
SPECIFICATIONS
• For all models
– The receiver manages "O-Code" radio encoding with vari-
able code (rolling-code), which enables use of all the new
functions in the NiceOpera system.
The receiver is compatible also with "FloR", "TTS", "Smilo"
and "Flo" encoding systems. However, in this case some of
the exclusive NiceOpera system functions described in
this manual cannot be used.
– The receiver has a capacity of 1024 spaces in which to
memorise transmitters. If the transmitter is memorised in
"Mode I", all the relative keys will occupy 1 memory alloca-
tion; otherwise if memorised in "Mode II", each memorised
key will occupy 1 memory allocation (for memorisation pro-
cedures, see below in this manual).
– Each receiver has its own identification number called a
"Certificate".
This number enables access to a series of operations, such
as: Memorisation of new transmitters without the need for
direct intervention on the receiver and use of the O-View
unit, by means of the "T4 Bus" connection.
The sealed coupon in the product pack contains the sheet
with the certificate number of this receiver. Caution! – this
coupon must be kept in a safe place as it enables access to
data stored in the receiver, unless further protection meas-
ures are adopted, such as the use of a security password.
4
• For models with "SM" type connection
– These models can be used exclusively with the control units
fitted with an "SM" type connection (fig. 1). Note – to identify
compatible control units, refer to the Nice product catalogue.
– These models automatically recognise the characteristics of
the control unit to which they are connected and the receiv-
er self-installs as follows.
• If the control unit manages the "T4 Bus", the receiver
provides up to 15 different commands.
• If the control unit does not manage the "T4 Bus", the
receiver provides up to 4 different command channels.
Caution! – In both cases the number and variety of the
commands available depend on the type and model of con-
trol unit used. The "Table of commands" of each control unit
is provided in the instruction manual of the relative control
unit.
• For models with universal type connection
– These models operate with 2 voltage-free contact relays
and therefore can be used with any type of control unit.
• For models with "T" in the model name
– These models are equipped with a "Repeater" function (see
below in this manual) which enables an increase in the trans-
mission range of the transmitters. They also enable "wireless"
communication with the O-Box programming unit.