Wet/Dry Vac Assembly - RIDGID WD16800 Mode D'emploi

SP6779-3 Ridgid WD1680 ES

Wet/Dry Vac Assembly

1. Locate the lid assembly and the drum
assembly (assembled earlier).
2. Position the lid assembly with the
detachable blower handle of the unit
located above the vacuum inlet on the
dust drum.
3. To assemble the lid assembly to the
drum assembly, lower the lid assembly
onto the dust drum. Rotate both
latches down until you hear them snap
over the drum latch catches of the
drum.
Detachable
Blower
Handle
Vacuum
Inlet
9/20/12 12:05 AM Page 8
8
Lid Assembly with
Detachable Blower
Drum Latch
Drum Catch
Inlet
Dust Drum
Assembly
Drain Cap