Positioning Detachable Blower (Power Head Assembly) - RIDGID WD16800 Mode D'emploi

SP6779-3 Ridgid WD1680 ES
Positioning Detachable Blower
(Power Head Assembly)
1. To remove the detachable blower from
the lid assembly, press down on the
detachable blower latch under the
detachable blower handle and lift the
blower off the lid of the Vac.
Detachable
Blower
Latch
2. To replace the detachable blower onto
the lid assembly, position detachable
blower above the indented area of the
lid assembly. Rotate the detachable
blower down until the travel of the unit
stops.
9/20/12 12:05 AM
3. Lightly press down on the carry handle
of the detachable blower until you
hear the "snap" of the detachable
blower latch engaging the detachable
blower. The detachable blower is now
latched to the lid assembly.
Detachable
Blower Handle
Detachable
Blower Latch
Detachable
Blower
Molded
Leads
4. Your new Wet/Dry Vac is ready for
use. With the Wet/Dry Vac completely
assembled and ready for use, insert
the push button end of the "Dual-
Flex™ Locking" hose into the inlet of
the Vac. The hose should snap into
place. To remove the hose from the
Vac, press the release button in the
hose assembly and pull the hose out
of the Vac inlet, as shown.
Press and Pull
Release
Button
9
Page 9
Detachable
Blower