Installing Tool Holder; Wet/Dry Vac Assembly; Insert Hose - RIDGID WD1850 Mode D'emploi

SP652816Gallon.qxd 5/12/06

Installing Tool Holder

1. Install tool holder as shown with
extension wand holders facing unit.
Tote Snaps

Wet/Dry Vac Assembly

1. Position the powerhead assembly on
the drum/caddy assembly as shown
(assembled earlier).
2. Rotate both latches down and press
until you hear them snap over the
flanges on the drum.
Drum
Latch
Powerhead
Assembly
Latch
Drum
11:45 AM Page 9
2. As an alternative storage solution, the
tool holder may hang on a wall. Two wall
mounting hooks (not provided) must be
secured to the wall as shown (sold
Tote
Straps (4)
separately).
Handle
Extension
Wand
Storage
Locations

Insert Hose

Insert the push button end of the "Tug-A-
Long" hose into the inlet of the vac. The
hose should snap into place. To remove
the hose from the vac, press the release
button in the hose assembly and pull the
hose out of the vac inlet, as shown.
Press
Drum
and
Latch
Pull
Drum
Flange
9
Grommet
Wall Mount
Hook
Wall
Release
Button