Installing And Connecting The Unit; Installing The Unit - Pioneer SBX-B30 Mode D'emploi

Masquer les pouces Voir aussi pour SBX-B30:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22
8
Installing and Connecting the Unit
En
Chapter 2
Installing and
Connecting the Unit
Before connecting the unit or changing the
connections, be sure to turn off the power and
disconnect the power cord from the outlet.
Also, make sure you have finished connecting
all cables before connecting the power cord to
the wall outlet.

Installing the Unit

If you are placing the unit directly under a
TV, only place a TV of 40 kg or less within the
allowable placement area.
600 mm
Dotted range : Possible placement area
Dotted range : Possible placement area
Caution
• Do not place a TV stand on top that is larger than
the placement possible area.
• Do not install the unit in an unstable place such
as on an unsteady stand or tilted surface. The unit
may fall or tip over, resulting in injury.
• The unit is not magnetically shielded and so should
be used away from a cathode ray tube (CRT) TV
or monitor. Also, do not place devices that are
easily influenced by magnetism (magnetic cards,
watches, video tapes, etc.) near the unit.
• Do not attach this unit to the wall or ceiling. It may
fall off and cause injury.
1 Place the unit.
Caution
• There are subwoofers located on the bottom of the
unit. Make sure that there is nothing between the
unit and the surface it is being placed on it.
2 Wire the unit.
In order to make the wiring process as easy
as possible, complete all wiring prior to
placing the TV on top of the unit.
3 Place the TV on top of the unit, and then
wire the TV.
310 mm
To enable hearing of the TV audio with the
unit, connect the supplied optical digital
audio cable.
For a TV that only has an analog audio
output terminal, connect the audio output
of the TV and the analog terminal of the unit
with a commercially available audio cable.
Optical digital
audio cable
(included)
Remove the protection cap at
the end and then connect the
cable while paying attention
to the orientation of the
connector.
If you will not use
the cable for your TV
connection, you can
use it to connect your
CD player or other
audio device.
Subwoofer
TV
Analog cable
(commercially
available)
Rear View
If your TV does not
have a digital terminal,
connect it to the analog
terminal.

Publicité

Table des Matières
loading

Table des Matières