GBC FUSION 1100L Mode D'emploi page 6

GB
getting ready to laminate
Easy Set Up
1 Take the electrical plug and place in an appropriate power source, which is near the table you
intend to use.
2 The laminator will respond with a single beep and a sequence of brief flashes across the control
panel.
3 To use the laminator move the slider to the right from the '
depending on which pouch selected. Below the slider you will see a white line, this indicates that
you have switched the laminator on.
Visual & Audible Ready Alerts
4 The laminator will start to warm up - an orange light will be illuminated to the right of the '
When the laminator is ready to use the green light next to the 'tick
series of two beeps are heard.
NOTE: only use 75micron/80 micron, 100
micron or 125 micron pouches with
this laminator.
loading the pouch
1 Take your item to be laminated and place in to the appropriate sized laminating pouch,
ensuring it is firmly located along the sealed edge. This is to help ensure that you get optimal
quality output.
NOTE: Do not cut pouches prior to
lamination.
Before laminating important or unique documents, always run a test pouch through
the laminator using a similar type document.
6
register this product online at www.accoeurope.com
' to the 75 mic or 125 mic position
a
' is illuminated (b) and a
NOTE: Your new laminator may emit a slight
odour during the initial operation. Its
is normal and will diminish after a few
hours of operation.
SEALED EDGE
A3, A4, A5, etc.
b
' (a).
SEALED EDGE
Irregular shaped item