Assemble Storage Basket
see images
-
11
13
Assemble & Detach Armbar
see images
-
14
18
Assemble & Detach Hood
see images
-
20
26
The completely assembled stroller is shown as
27
Stroller Operation
Adjust Recline
see images
-
28
31
Use Hood
see images
32
Adjust Calf Support
see images
-
33
34
The calf support has 2 positions.
To raise the calf support, lift it upwards.
Use Buckle
see images
-
35
36
!
To avoid serious injury from falling or sliding out, always secure your child with harness.
!
Make sure your child is snugly secured. The space between the child and the shoulder harness is about the
thickness of one hand lay flat on child's chest.
!
Do not cross the shoulder belts. This will cause pressure on a child's neck.
Use Shoulder & Waist Harnesses
see images
-
37
40
!
In order to protect your child from falling out, after your child is placed into the seat, check whether the
shoulder and waist harnesses are at proper height and length.
37
- 1
Shoulder harness anchor A
37
- 2
Shoulder harness anchor B
37
- 3
Slide adjuster
For larger child, use shoulder harness anchor A and the highest shoulder slots.
For smaller child, use shoulder harness anchor B and the lowest shoulder slots.
15
To adjust the position of the shoulder harness anchor, turn the anchor to be level with the side facing forward.
Thread it through the shoulder harness slot from back to front.
child's shoulder height.
39
Use slide adjuster to change the harness length.
40
- 2
Press the button
40
, while pulling the waist harness to proper length
Use Front Swivel Lock
see images
41
Pull up the front swivel locks to maintain the moving direction.
Tip
It is recommended to use swivel locks on uneven surfaces.
Use Brake
see images
-
42
43
To lock wheels, step the brake lever downwards.
42
To release wheels, just lift the brake lever upwards.
Tip
Always set the parking brake when stroller is not moving.
Fold Stroller
see images
-
44
47
!
Please fold the hood before folding the stroller.
!
Please do not lock swivel while folding to avoid folded stroller unable to stand.
-1
Push secondary lock
and squeeze one-hand-fold handle
45
47
stroller, then the stroller can stand when folded.
Use Accessories
Accessories may be sold separately or may not be available depending on region.
Use Rain Cover
see images
48
To assemble the rain cover, place it over the stroller, then attach it on the handle by hook and loop fasteners
and wrap the webbings on the rain cover around the mounts, and then snap buttons.
!
When using the rain cover, please always check its ventilation.
!
When not in use, please check that the rain cover has been cleaned and dried before folding.
!
Do not fold the stroller after assembling the rain cover.
!
Do not place your child into the stroller assembled with rain cover during hot weather.
Use with Joie Infant Child Restraint
see images
-
49
52
When using with Joie infant child restraint gemm, please refer to the following instructions.
!
Recline the stroller rear seat to the lowest position.
Rethread it through the slot that is closest to
38
-1
- 3
40
41
43
44
-2
. Pull the armrest rearwards to fold
45
48
16