Starting Up; Using The Cable Set To Connect The Cruise 2.0 To Lead Batteries (Acid, Gel, Agm) - Torqueedo Cruise 2.0 Mode D'emploi

8. Starting up

8.1 Using the cable set to connect the Cruise 2.0 to lead batteries
(acid, gel, AGM)
The Cruise 2.0 operates with a power supply of between 20 V and 30 V (relating to the no-
minal voltage). That means it can be operated with two serially configured 12 V lead-acid,
lead-gel or AGM batteries.
To increase the capacity, several pairs of serially configured 12 V batteries can be
configured parallel to each other ( not recommended - see Basic information on battery
supply).
1. Start by connecting the cable set to the batteries. First switch the cable set master
switch to the off or zero position.
2. Connect the negative terminal of the cable set (identified by the marking) to the
negative pole of the first battery.
3. Then use the connection cable provided to connect the positive pole of the first battery
to the negative pole of the second battery.
4. Then connect the positive connection terminal of the cable set, which includes a fuse,
to the positive pole of the second battery.
5. Now connect the high current plug of the cable set to the high current plug of the
motor.
6. Switch the master switch to the on position. Now your motor is ready to go.
The cable set comes complete with a CF8 125 A fuse. In case of a short circuit, the fuse
cuts the circuit and prevents any further damage.
The high-current plugs are always identical. Connect them by holding them against each
other and turning by 180°.
The plug contacts are designed to prevent polarity inversion.
7. Operating elements 8. Starting up
Operating instructions
17