Physical Data; Electrical Data - Daikin UATYQ250MCY17 Manuel D'installation

Conditionneurs d'air en toiture

Table des Matières

Heat Pump (R410A)

Refrigerant charge

Evaporator air flow

External static pressure

Condenser air flow

Control wire length (Standard/Max) : Size

Compressor (Type/Quantity)

Air filter (Type/Quantity)

Air filter dimension (Length x Width x Thickness)

Heat Pump (R410A)

Power supply

Max continuous current (Comp)

Full load current (FLA, Comp)

Locked rotor current (LRA, Comp)

The equipment fulfils the requirements in EN 61000-3-11 and is subject to conditional connection to the mains. It may

be connected in consultation with the supply authority. The equipment may only be connected to a mains supply with

a system impedance of less than the value stated in table below. The system impedance in the interface point may be

obtained from the supply authority.

If the mains supply has a higher system impedance, short voltage dips may appear when the equipment is started or

during operation. This may influence or disturb the operation of other apparatuses, e.g. flickering lamps, especially those

connected to the same supply mains.

PHYSICAL DATA

880 x 467 x 4 1126 x 385 x 4 1126 x 435 x 4 1497 x 392 x 4 1497 x 495 x 4 1497 x 595 x 4 1497 x 595 x 4

6450/6450 10100/10100 10600/10600 10600/10600

Wired Rooftop Controller

15 / 100 : 3

Washable Saranet/2

380-415/3N~/50

Maximum impedance (Z