Britax MULTI-TECH II Mode D'emploi page 16

6. Installation of your child seat (facing forward) with seatbelts for
adults
15-25 kg group 2 (approx. 4 years – 6 years)
6a
6c
6e
6g
6b
6d
6f
6h
Adjusting the child seat
In order to remove the belt on the child seat,
place the child seat on the oor.
Press the adjustment button and
simultaneously pull BOTH
forward as far as possible
Turn the seat around. Lift the belt adjuster on
the back of the seat and slide it up until the
shoulder strap slots are on the top position in
the headrest (Fig. 6b).
Unhook both shoulder straps from the
bracket on the back of the child seat
6c), lay the brackets on the bottom section of
the shell (Fig. 6g).
Remove the chest pad from the chest pad
fasteners (Insert in Fig.
shoulder straps and the chest pads through
toward the front of the seat and remove the
chest pads from the shoulder straps.
Lay the child seat on its back. Remove
the adjusting belt from the bracket of the
shoulder strap. Turn the bracket so that is ts
through the graduated belt and push it onto
the front of the seat (Fig.
Place the child seat upright and remove the
belt from the buckle (Insert in Fig.
the belt brackets and buckle tongues under
the cover through the lap belt holes
Put the buckle, belt straps and chest pads
into the elastic holding straps
Thread the adjustment straps through the
recess in the cover.
Support the seat and clip the headrest
adjuster onto the back of the headrest
(Fig. 6g).
Check whether the chest pads have been
removed, as shown above in
Lift the headrest until the head is position
in the middle (Fig. 6h). If the headrest is in
the correct position, release the headrest
adjuster and check that the headrest locked
into position.
shoulder straps
(Fig. 6a).
(Fig.
6c). Pull both
6d).
6e). Push
(Fig. 6e).
(Fig. 6f).
(Fig. 6c).