Changing The Batteries In The Battery Holder (L Models Only); Turndown (L Models Only) - Napoleon Acies Série Manuel Du Propriétaire

operating your appliance
EN

2.5.1 changing the batteries in the battery holder (L models only)

WARNING
!
• Ensure the gas and electrical power to the appliance is turned off.
• Appliance may be hot, do not service until the appliance has cooled.
note:
In the event of a power failure, your appliance can be operated using the supplied battery back-up. If a power
failure occured, remove the batteries from the holder once the power has been restored. The system will drain
the batteries if they are left in the battery holder.
A.
Turn off the gas and disconnect the electrical power supply from the appliance.
B.
Remove the safety barrier, control cover and door trim to easily access the control compartment (see
"maintenance" section for instructions on how to remove these components.
C.
Locate the battery housing located near the control board (see illustration below).
D.
Open the battery housing by sliding the back piece upwards and off of the battery housing. Remove the
four "AA" alkaline batteries and install four new "AA" alkaline batteries into the battery housing. Ensure the
positive and negative ends correspond with those identifi ed on the holder.
E.
Place the battery housing back into the control compartment, ensure that the battery housing is placed in
a clean and easily accessible location.
F.
Reinstall the safety barrier. The safety barrier must be installed at all times during the appliance operation.
G.
Turn the gas and electrical power back on to begin operating the appliance.

2.5.2 turndown (L models only)

Manual adjustments to your fi replace must only be made when the appliance is off and complete cool.
Allow safety barrier to cool before making adjustment.
The Acies Series is equipped with a manual gas control knob (located on the valve) that adjusts the fl ame height to
suit your preference. To access the gas control knob, remove your safety barrier, control cover and door trim (see
"maintenance" section for instructions on how to remove these components.
Use only your hand to turn the gas control knob (never use tools). If the knob will
not turn by hand, do not try to repair it. Contact a qualifi ed technician.
12
W415-2036 / A / 10.18.19
Red wire Control module
Black wire
Battery housing
Flame adjustment