On-Board Mounting.
Mount the charger near the battery, ensuring the cables and charger are secure and away from any moving parts (eg. fan blades, belts, pulleys). Secure the
provided mounting bracket to the vehicle's chassis using the two included self-tapping screws. For best results, mark the position using the bracket, and pre-drill
two small pilot holes. Once the bracket is secured, use the velcro strap to secure the Genius 2D in place.
Connecting to the Battery.
Do not connect the AC power plug until all other connections are made. Identify the correct polarity of the battery terminals on the battery. Do not make any
connections to the carburetor, fuel lines, or thin, sheet metal parts. The below instructions are for a negative ground system (most common). If your vehicle is a
positive ground system (very uncommon), follow the below instructions in reverse order.
1.) Connect the positive (red) eyelet terminal connector to the positive (POS,P,+) battery terminal.
2.) Connect the negative (black) eyelet terminal connector to the negative (NEG,N,-) battery terminal.
3.) Connect the battery charger's AC power plug into a suitable electrical outlet.
Begin Charging.
1.) Verify the voltage and chemistry of the battery.
2.) Confirm that you have connected the eyelet terminal connectors properly and the AC power plug is plugged into an electrical outlet.
3.) All LEDs will flash momentarily, then the charger will begin charging without user intervention.
4.) The charger can now be left connected to the battery at all times to provide maintenance charging.