How To Use - NOCO Genius 2D Mode D'emploi

device, stop using the product immediately and consult your physician. Medical Conditions. If you have any medical condition that you believe could be affected
by product, including but not limited to; seizures, blackouts, eyestrain or headaches, consult your physician prior to use of product. Cleaning. Power off the product
before attempting any maintenance or cleaning. Clean and dry product immediately if it comes in contact with liquid or any type of contaminant. Use a soft, lint-free
(microfiber) cloth. Avoid getting moisture in openings. Explosive Atmospheres. Obey all signs and instructions. Do not operate product in any area with a potentially
explosive atmosphere, including fueling areas or areas which contain chemicals or particles such as grain, dust or metal powders. High-Consequence Activities.
This product is not intended for use where the failure of the product could lead to injury, death or severe environmental damage. Radio Frequency Interference.
Product is designed, tested, and manufactured to comply with regulations governing radio frequency emissions. Such emissions from the product can negatively
affect the operation of other electronic equipment, causing them to malfunction. Model Number: Genius 2D This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his/her own expense.

How To Use

Charging Modes.
The Genius 2D has two (2) automatic modes, and will begin charging when both the battery and power are connected. Do not operate the charger until you confirm
the Genius 2D charger is compatible with your battery type and voltage. Below is a brief description:
Mode Explanation
The charger is connected to AC power but no battery is detected, and the charger is not charging. Energy Save is activated during this mode,
drawing microscopic power from the electrical outlet.
Standby
No Power
For charging 12-volt Wet Cell, Gel Cell, Enhanced Flooded, Maintenance-Free, Calcium batteries and AGM.
12V NORM
14.5V | 2000mA | Up To 40Ah Batteries | Maintain all sizes