Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
If the descaling indicator (6) flashes, the
appliance must be descaled. It is still
possible to brew coffee.
•
If the descaling indicator (6) lights
continuously, the descaling program is
running.
The automatic descaling program of the
appliance is optimised to be used for 125 ml of
durgol
swiss espresso
. The product is used
®
®
undiluted, is highly effective and guarantees a
reliable descaling and therefore a long
operational life of the appliance. The descaling
agent is available from our service station.
Before you proceed, we need you to pay
attention to the following notes:
-
Be careful when descaling the appliance to
prevent damage to furniture or clothing.
Place an empty pot (at least 1.2 l) under
the coffee dispenser (8) in such a way as to
prevent splashes.
Before you proceed, we would like you to
focus your attention on the following notes:
-
Only use durgol
swiss espresso
®
specified quantity to descale the appliance.
-
Do not use vinegar or vinegar concentrate
to descale the appliance.
-
Do not use citric acid to descale the
appliance.
•
Fill the empty water reservoir (12) with
durgol
swiss espresso
®
with fresh water (1 l).
•
Place the water reservoir (12) into the
appliance.
•
Insert the empty coffee pad cassette (11)
into the appliance.
•
Set the locking collar (7) to position 'A'.
•
Place an empty pot (at least 1.2 l) under
the coffee dispenser (8).
•
Press the on/off button (1) to switch on
the appliance.
•
Keep both start/stop buttons (2/3) pressed
simultaneously to start the descaling
process. The descaling indicator (6)
illuminates yellow.
•
After approximately 15 minutes, the low-
water indicator (4) flashes yellow.
•
Empty the pot and place it back under the
coffee dispenser (8).
•
•
•
•
•
•
•
•
in the
®
Refer to the table below to solve problems
yourself. If you are not able to solve the
problem yourself, contact our service station.
•
(125 ml) added
®
•
•
•
9
Fill the empty water reservoir (12) with
fresh water (1 l). The ready-to-brew
indicator (5) flashes green.
Press the start/stop button (2/3) to start
the first rinsing cycle.
After approximately 2 minutes, the first
rinsing cycle.is competed. The low-water
indicator (4) flashes yellow.
Empty the pot and place it back under the
coffee dispenser (8).
Fill the empty water reservoir (12) with
fresh water (1 l). The ready-to-brew
indicator (5) flashes green.
Press the start/stop button (2/3) to start
the second rinsing cycle.
After approximately 2 minutes, the second
rinsing cycle.is competed. The descaling
process is completed. The appliance
switches off automatically.
After descaling the appliance, clean the
dispenser cassette (9), the coffee dispenser
filter (10) and the coffee pad cassette (11)
in soapy water using a soft brush.
Troubleshooting
The water reservoir cannot be mounted.
- Hold the holes in the bottom of the
tilting mechanism and tilt the tilting
mechanism forward.
The water level indicator flashes, but the
water reservoir is filled.
- Empty the water reservoir.
- Shake the empty water reservoir to
check whether the float moves freely.
- Clean or descale the water reservoir.
The pump makes loud noises.
- Make sure that the cover of the filter
holder is correctly placed in the water
reservoir.
- Rinse the appliance.
The locking collar (7) is blocked far before
reaching position 'A'.
- Make sure that the coffee pads are
correctly placed in the coffee pad cassette.
Publicité
Table des Matières
