Bosch TES 803F Série Mode D'emploi page 49

Cleaning the milk system
Duration: approx. 1 minute
Cleaning and service
Short rinse
milk system
Calc'nClean
The milk system 10 can be pre-cleaned
automatically.
à
● Press the button 3.
Short rinse milk system
● Press the start button 8.
Place glass under frother, place
suction pipe in glass
● Place an empty glass under the milk
system 10 and put the end of the pipe
10d in the glass.
● Press the start button 8. The milk system
is cleaned automatically.
● Now empty the glass and clean the
suction pipe 10d.
In addition to this, clean the milk system
thoroughly at regular intervals (by hand or
in the dishwasher).
start

start

start

Descaling
Duration: approx. 30 minutes.
Cleaning and service
Descale
Clean
The start button 8 flashes while the different
descaling processes are running.
The figures on the top right indicate the
progress of the programme.
Important: If there is a water filter in the
water tank 11, it needs to be removed
before the service programme is run.
à
● Press the button 3.
Descale start

● Press the start button 8; the display 5 will
guide you through the programme.
Empty drip tray
Replace drip tray
● Empty the drip tray 23 and reinsert it.
Place 1 l container
Place suction pipe in container
● Place a container with 1 litre capacity
under the milk frother 10.
● Place the end of the suction pipe 10d in
the container.
● Press the start button 8.
Remove filter start

Info: If the water filter is activated, the dis-
play will prompt you to remove the filter,
then press the start button 8 again.
en
start

start

45