Before Using For The First Time - Bosch TES 803F Série Mode D'emploi

Before using for the
first time
General
Fill the appropriate container using only
pure, cold, uncarbonated water and only
roasted beans (preferably espresso or
coffee bean blends for fully automatic coffee
machines). Do not use coffee beans that
have been glazed, caramelised or treated
with other additives containing sugar, since
they will block the brewing unit.
The water hardness setting can be adjusted
on this appliance. The factory setting for
the water hardness is 4. Check the hard-
ness of the water you use with the enclosed
test strip. If a value other than water hard-
ness 4 is displayed, change the setting on
the appliance accordingly after switching on
(see "Menu settings –
Setting up the appliance
● Place the fully automatic espresso
machine on a flat, water­resistant surface
that can take its weight.
Important: Only use the appliance in
frost-free rooms. If the appliance has been
transported or stored at temperatures below
0 °C, wait at least 3 hours before operation.
● Pull out the mains plug from the cable
compartment 24 and plug it in. Adjust the
length of the cable by pushing it back in
and pulling it out. To do this, place the
appliance with its back flush with the edge
of the work surface and either pull the
cable downwards or push it upwards.
● Lift the lid of the water tank 12.
● Remove and rinse the water tank 11 and
fill it with fresh, cold water. Do not fill
above the "max" mark.
● Replace the water tank 11 and push it
firmly downwards into place.
● Close the water tank lid 12 again.
● Fill the bean container 15 with coffee
beans.
Water hardness
● Press the power switch 1 O / I. The start
button 8 lights up and the different lan-
guages appear in the display 5.
The following languages can be selected:
Deutsch
Français
Italiano
● Use the buttons
language in which you want the display
texts to appear.
").
The selected language is highlighted.
● Press the start button 8. The language
you selected is saved.
● The brand logo lights up in the display 5.
The appliance now heats up and rinses.
Some water will run out of the coffee
outlet 9.
● The appliance is ready for use when the
symbols for the drink selection and the
start button 8 light up in the display 5.
Espresso
 à À Á Å Æ
Info: The factory settings of the fully auto-
matic espresso machine are programmed for
optimal performance. The appliance switches
off automatically after a specific time (see
"Menu settings –
English
Nederlands
< >
4 to select the
and
Sprache
Deutsch start

English
Français
ËË Í
").
Auto Off after
en
31