Bosch TES 803F Série Mode D'emploi page 47

Cleaning the milk system
Important: The milk system 10 must be
cleaned immediately after use!
The milk system 10 can be pre-cleaned
automatically (see "Service programmes"
or cleaned manually.
Dismantling the milk system 10 for cleaning:
● Pull the milk system 10 forward out of the
appliance.
● Turn the upper part 10a in an anti-
clockwise direction and remove from the
lower part 10b.
● Clean the individual parts with detergent
solution and a soft cloth.
● Rinse all parts with clean water and dry.
● Put all the parts back together. The milk
frother can then be clicked back into
place in the appliance.
Info: All parts of the milk frother 10 can also
be put in the dishwasher.
Cleaning the brewing unit (Fig. F)
(refer also to the quick reference guide)
In addition to the automatic cleaning pro-
gramme, the brewing unit 20 should be
removed regularly for cleaning.
● Switch the appliance off completely at
the power on/off switch 1 O / I; no buttons
are lit.
● Take hold of the door to the brewing
unit 19 at the bottom and open it.
● Slide the red lock 20a on the brewing
unit 20 completely to the left.
● Press the eject lever 21 down fully.
The brewing unit is released.
● Grasp the brewing unit 20 by the
recessed grips and remove carefully.
en
43