Front And Panel Commands; Inside Space; Replacing An Drawer Light; To Replace A Light Bulb - Fulgor Milano F6PWD30 Série Instructions Pour L'installation Et L'utilisation

EN

Front and panel commands

The use of a moist cloth is sufficient when cleaning the
appliance. In the event the appliance requires further
cleaning, add drops of detergent in the water. Dry the
appliance with a dry cloth. The steel front of the appliance
can be cleaned with products specifically designed for steel.
Such products prevent the formation of dirt on the surface of
the drawer. Apply a minimal amount of the product on a soft
and apply it to the surface of the appliance.

Inside space

To clean the inside space use a moist cloth. In the event the
appliance requires further cleaning add drops of detergent
to the water. Dry the surface with a dry cloth. Make sure to
avoid water draining into the ventilation holes. Only use the
appliance after the drawers are dry completely.

Replacing an Drawer Light

• Each warming drawer is equipped with three halogen lights
located in the lateral walls.
• Each light assembly consists of a removable lens, a light
bulb as well as a light socket housing that is fixed in place.
See figure on this page.
• Light bulb replacement is considered to be a routine
maintenance item.

To Replace a Light Bulb

1. Read WARNING on this page.
2. Turn off power at the main power supply (fuse or breaker
box).
3. Remove the lens between screw and glass using a screw
driver.
4. Remove the light bulb from its socket by pulling it.
5. Replace the bulb with a new one. Avoid touching the
bulb with fingers, as oils from hands can damage the
bulb when it becomes hot.
6. The bulb is halogen: use one with the same type checking
Voltage and Wattage.
7. Place the lens back on.
Turn power back on at the main power supply (fuse or
breaker box).
WARNING
• Make sure the lights are cool and power to the drawer has
been turned off before replacing the light bulb(s). Failure
to do so could result in electrical shock or burns.
• The lenses must be in place when using the drawer.
• The lenses serve to protect the light bulb from breaking.
• The lenses are made of glass. Handle carefully to avoid
breakage. Broken glass could cause an injury.
8