Custom Drawer Front - Fulgor Milano F6PWD30 Série Instructions Pour L'installation Et L'utilisation

EN

Custom drawer front

(Only for Push to Open Drawer)
Custom panels must meet the following requirements:
• Have a minimum thickness of 3/4" (19 mm).
• Have all edges finished.
• If using wood, the back must be sealed to prevent moisture
damage.
• Be capable of withstanding temperatures above 158 °F (70
°C).
B
Dimensions
A
B
C
D
12
C
D
=
inches
29 - 5/ 8" to 29 - 7/8"
10 - 3/ 8"
7 - 5/ 8"
8 - 13/16"
Custom Drawer Front Preparation
1. Mark pilot holes on the back side of the panel according to
the dimensions indicated in the following drawing.
2. Drill pilot holes with a 3/32" (2.5 mm) drill bit. Be careful
not to drill all the way through the panel. Pilot holes should
only be 7/16" (11 mm) deep.
D D
A
PILOT HOLES
7/16" (11 mm)
dia. 3/32"
(2.5 mm)
=
mm
754 to 758
264
193
224