Technical Data; Installation Notes - Fulgor Milano F6PWD30 Série Instructions Pour L'installation Et L'utilisation

EN

Technical data

120 Volts 60 Hz
Amperes
9,2

Installation notes

1. The warming drawer support surface must be a minimum
3/4" (2cm) thick plywood platform.
It must support 100 pounds.
The platform must be solid, level and flush with the bottom
of the cabinet cut out.
2. Use extreme caution when moving or installing the drawer.
It is very heavy.
DO NOT LIFT THE WARMING DRAWER BY THE DRAWER
HANDLE.
3. Be very careful when moving or installing the warming
drawer to avoid damage to the frame or damage to the
cabinets.
4. For best performance results make sure the warming drawer
is leveled before completing installation. There is no way to
level the warming drawer after it has been installed. If the
installation is not level, the door may slide open or not seal
tightly, allowing heat to escape.
NOTE: If installing the warming drawer below another
product, refer to that product's literature for any installation
requirements.
5. Be careful when placing drawer. DO NOT pinch the conduit
between the drawer back.
WARNING
Before installing or removing, turn power OFF at the service
panel. Lock service panel to prevent power from being
turned ON accidentally.
Securely fasten drawer to cabinet using the screws provided.
Failure to do so could result in warming dreawer moving or
tipping during use and causing damage to the drawer or
cabinets or personal injury.
Know how to disconnect the power to the warming drawer
at the circuit breaker or fuse box in case of an emergency.
CAUTION
Unit is heavy and requires at least two people or proper
equipment to move.
10
Power Supply
Watts
1100
INSTALLATION OPTIONS
INSTALLATION BELOW A SINGLE OVEN
24" (610) Min. Inside
Oven
Cutout
9-1/4"
(235)
28-3/8"
(722)
1" Min. Above Toekick or Adjust o Oven Installation Height
INSTALLATION BELOW A DOUBLE OVEN
24" (610) Min. Inside
Oven
Cutout
9-1/4"
(235)
28-3/8"
(722)
1" Min. Above Toekick
Allow 5/8"
Overlapon All Sides
3/4" Min.
(2) Min.
Allow 5/8" Overlap
on All Sides
3/4" Min.
(2) Min.