Monacor International img Stage Line MMX-842 Mode D'emploi page 9

9) Adjust the definite volume of the master sig-
nal with the control MAIN MIX (25) by means
of the LED level indication (24).
In general, an optimum level control is
reached at 0 dB. However, if the output level
of the mixer is too high or too low for the fol-
lowing unit, the master signal must be
adjusted to a correspondingly higher or lower
level. In case of overload the red LEDs CLIP
light up.
5.2.1 Adjusting the effect send way
The effect unit must be connected as described
in chapter 4.3.2.
1) First turn the level control AUX RETURN (15)
approx. to mid-position so that the following
effect adjustments can be heard.
2) Mix the signals of the channels 1 to 7/ 8 to the
effect way with the controls FX (6). With
these controls it is possible to adjust the
desired effect intensity separately for each
channel.
3) Mix the signal processed by the effect unit to
the master signal with the control AUX
RETURN. With this control the effect intensity
for all channels can be increased or reduced
together.
5.3 Monitoring via headphones
and monitor system
The button TAPE TO CTRL ROOM (16) deter-
mines the signal to be monitored via the outputs
PHONES (12) and CTRL ROOM OUT (13) and
indicated via the LED level indication (24):
– If the button is not pressed , the master signal
adjusted with the control MAIN MX (25) is
monitored and indicated
– If the button is pressed , the input signal at the
jacks TAPE IN (14) is monitored and indicated
(e. g. backtrack recording).
Adjust the monitoring volume with the control
PHONES / CONTROL ROOM (18).
6 Specifications
Input sensitivity
Mic: . . . . . . . . . . . . . . . 0.5 mV
Line In: . . . . . . . . . . . . 60 mV
Aux Return: . . . . . . . . . 30 mV
Tape In: . . . . . . . . . . . . 160 mV
Insert (return): . . . . . . . 50 mV
Output level
Main Out / Tape Out: . . 800 mV
(at indication 0 dB)
Ctrl Room Out: . . . . . . max. 3 V
FX Send: . . . . . . . . . . . max. 1.6 V
Headphone impedance: . ≥ 8 Ω
Frequency range: . . . . . . 20 – 20 000 Hz
THD: . . . . . . . . . . . . . . . . < 0.04 %
Crosstalk: . . . . . . . . . . . . -63 dB
S / N ratio: . . . . . . . . . . . . 85 dB (A weighted)
Equalizer
bass range: . . . . . . . . . ±15 dB / 80 Hz
midrange: . . . . . . . . . . ±15 dB / 2.5 kHz
high range: . . . . . . . . . ±15 dB / 12 kHz
Phantom power: . . . . . . . +48 V
Power supply: . . . . . . . . . via supplied power
supply unit connected
to 230 V~ / 50 Hz
Ambient temperature: . . . 0 – 40 °C
Audio connections
Mic, mono: . . . . . . . . . . XLR / 6.3 mm jack
(bal.)
Insert: . . . . . . . . . . . . . 6.3 mm jack (unbal.)
Line In, stereo: . . . . . . 6.3 mm jack
Left / Right (bal.)
Aux Return, stereo: . . . 6.3 mm jack
Left / Right (unbal.)
Tape In / Out, stereo: . . RCA
Left / Right (unbal.)
Main Out, stereo: . . . . . 6.3 mm jack
Left / Right (unbal.)
FX Send, mono: . . . . . 6.3 mm jack (unbal.)
Phones, stereo: . . . . . . 6.3 mm jack (unbal.)
Ctrl Room Out, stereo: 6.3 mm jack
Left / Right (unbal.)
Dimensions: . . . . . . . . . . 245 × 50 × 225 mm
(W × H × D)
Weight: . . . . . . . . . . . . . . 2 kg
Subject to technical modifications.
All rights reserved by MONACOR
manual may be reproduced in any form or by any means for any commercial use.
Configuration of XLR plug and 6.3 mm plug
XLR plug for balanced connection
1 = ground
2 = signal +
3 = signal
3-pole 6.3 mm plug
for balanced connection
2-pole 6.3 mm plug
for unbalanced connection
3-pole 6.3 mm plug
for the jack INSERT
6.3 mm stereo plug
for the headphone connection
® INTERNATIONAL GmbH & Co. KG. No part of this instruction
GB
-
T = signal +
-
R = signal
S = ground
T = signal
S = ground
T = Send (output)
R = Return (input)
S = ground
T = left channel
R = right channel
S = ground
9