Card Programming - Ducati CTR45 Manuel D'emploi

L) Card programming
"Step-by-step" logic
JP3 JP2 JP1
JP1 - jumper not inserted
JP2 - jumper not inserted
JP3 - no effect
"Automatic" logic
JP3 JP2 JP1
JP1 - jumper not inserted
JP2 - jumper inserted
JP3 - no effect
"Condominium" logic
JP3 JP2 JP1
JP1 - jumper inserted
JP2 - no effect
JP3 - no effect
"Kickback" logic
JP3 JP2 JP1
JP1 - no effect
JP2 - no effect
JP3 - jumper inserted
Remote controls codes self-learning
Insert the Jumper JP1 and remove the Jumpers JP2 and JP3. Press the key P1 once to insert a Start code. Press
the key P1 twice to insert a Pedestrian Start code. Each time key is pressed, the led DL1 flashes in
acknowledgement. When the led is lit with a fixed light transmit the code to be learn by means of the remote control.
When the operation has ended, restore the Jumpers as in origin.
Erasing all stored codes
Insert the Jumper JP1 and remove the Jumpers JP2 and JP3. Press the key P1 until the led LD1 goes off (about 10
sec.). When the operation has ended, restore the Jumpers as in origin.
Setting the pause time
Insert the Jumper JP3 and remove the Jumpers JP2 and JP1. Press the key P1 until the led DL1 lights. Let the
desired pause time pass, then press the key P1 again (the led goes off). When the operation has ended, restore the
Jumpers as in origin.
Setting the work time (2-wings gates with time delay in opening and closing)
Insert the Jumper JP2 and remove the Jumpers JP3 and JP1. Make sure the gate is completely opened. If not,
position it manually. Press the key P1 for about 2 seconds (the led DL1 will light with a fixed light) until the motor M1
starts in closing. Let the desired delay time pass, then press the key P1 again to start the motor M2. When the motor
M1 has arrived at the end of travel, press the key P1 for the third time. when the motor M2 has arrived at the end of
travel, press the key P1 for the fourth time. When the operation has ended, restore the Jumpers as in origin.
Setting the work time (2-wings gates without any time delay)
Remove the Jumper JP1 and insert the Jumpers JP3 and JP2. Make sure the gate is completely opened. If not,
position it manually. Press the key P1 for about 2 seconds (the led DL1 will light with a fixed light) until the motors
contemporarily start in closing. When the motors have arrived at the end of travel, press the key P1 again. When the
operation has ended, restore the Jumpers as in origin
Setting the work time (1-wing gates )
Remove the Jumper JP3 and insert the Jumpers JP1 and JP2. Make sure the gate is completely opened. If not,
position it manually. Press the key P1 for about 2 seconds (the led DL1 will light with a fixed light) until the motor M2
starts in closing. When the motor M2 has arrived at the end of travel, press the key P1 again. When the operation
has ended, restore the Jumpers as in origin.
19
.
ENGLISH