Amoena CONTACT Mode D'emploi page 9

ENG
• If your skin tends towards dryness, apply moisturising skin care after wearing the
Contact breast form.
• For each Contact breast form and Contact breast shaper, a 3-month exchange
right applies. If you struggle to achieve adhesion within the first 3 months, you can
exchange it for a bra-supported Amoena product.
Putting On the Contact Breast Form
1. First clean your skin carefully. Then let the skin dry fully. The drier and cleaner your
skin is, the better the adhesion of the breast form. Please do not touch the adhesive
surface of the breast form, as this can impair the adhesion.
2. Now put on your bra and check the fit. Next pull your bra strap completely off your
shoulder and arm and lean forwards.
3. Using the hand from your non-operated side, take hold of the bra strap and pull the
cup away from the body.
4. Take the breast form in the other hand and place it in the cup of the bra. The upper
corner of the breast form should be close to the bra strap. Stay leaning forwards.
Make sure that the breast form sits well in the bra. See Diagram 1 page 3
5. Cup the outer edge of your bra with your free hand and slowly straighten up. As you
do so, carefully press the breast form onto your body.
6. Now pull the bra strap over your shoulder and press the breast form firmly into place
again. Diagram 2 page 3
7. Check the fit. If the breast form is not well positioned, lean forwards and start over.
Taking Off the Contact Breast Form
1. Cup the breast form with one hand as completely as possible, so that your fingertips
are near the edge, and lean forwards until you feel the weight of the breast form in
your hand. Starting at a point some distance from the scar, slowly pull the breast
form off the body.
2. If the adhesive surfaces accidentally stick together as they are removed, they can be
easily separated again under running water.
3. Please be careful with long fingernails. These can damage the coating of the breast
form.
General Care Instructions
• Skin texture and skin evaporations caused by e.g. medications and care products can
affect the adhesive strength. Please clean your breast form daily and thoroughly to
16
achieve optimal and long-term adhesion.
DE DE
• Only Amoena Soft Cleanser allows you to achieve optimum adhesion. Other cleaning
products can reduce the adhesive strength.
• Small clumps that form on the adhesive surface should not be removed. Do not use
any other cleaning agents such as abrasive powder or implements such as scissors or
tweezers. Clean the adhesive surface with the Amoena Soft Cleanser.
• The special brush should be replaced after 12 months at the latest.
Cleaning the Adhesive Surface
1. Add three drops of the Amoena Soft Cleanser to the dry adhesive surface and then
moisten the special brush with lukewarm water. See Diagram 3 Contact page 3
2. Using only the special brush, clean the adhesive surface well for approx. 3 minutes,
applying pressure and using circular movements. See Diagram 4 Contact page 3
3. Then rinse with plenty of lukewarm water.
4. Leave to air dry or dry with a hair dryer on a moderate setting.
ADAPT BREAST FORMS
Art. No. Article
326 Adapt Air Xtra Light 2SN
327 Adapt Air Light 2SN
328 Adapt Air Xtra Light 1SN
329 Adapt Air Light 1SN
376 Adapt Light 3A
All Adapt Air products are supplied with a pump.
General Instructions for Use
Amoena Adapt Air are breast forms with an integrated air chamber which
can be individually adjusted to fit the chest wall and the body's natural silhouette.
BALANCE ADAPT SHAPERS
Art. No. Article
233 Balance Adapt Air MD
234 Balance Adapt Air SV
ENG
17