Starting A Programme - AEG FSE62800P Mode D'emploi

1. To lift the basket pull the rack out of
the dishwasher by the rack handle.
The trigger handle should not be
used.
The basket is automatically locked on the
upper level. Load or unload the basket
carefully (refer to basket loading leaflet).
2. To lower the basket connect the
trigger handle with the basket frame
as shown below. Lift the trigger
handle and the rack up.
Once the trigger handle is lifted,
push the rack down. The mechanism
returns to its basic position on the
lower level.
There are two ways of lowering the
basket depending on the loading:
• If there is a full load of plates
slightly push the basket down.
• If the basket is empty or half-
loaded press the basket down.
9.2 Using the detergent
A B
C
CAUTION!
Only use detergent
specifically designed for
dishwashers.
1. Press the release button (A) to open
the lid (C).
2. Put the detergent, in powder or
tablets, in the compartment (B).
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the lid
locks into position.
9.3 Setting and starting a
programme
The Auto Off function
This function decreases energy
consumption by deactivating
automatically the appliance when it is not
operating.
The function comes into operation:
• 5 minutes after the completion of the
programme.
• After 5 minutes if the programme has
not started.

Starting a programme

1. Press the on/off button to activate
the appliance. Make sure that the
appliance is in programme selection
mode and door is closed.
ENGLISH 39