Description; Preparing For Commissioning - ATIKA KGSZ 210 Instructions D'utilisation

The electrical connection or repairs to electrical parts of
the machine must be carried out by a certified electrician or
one of our customer service points. Local regulations – es-
pecially regarding protective measures – must be ob-
served.
Repairs to other parts of the machine must be carried out
by the manufacturer or one of his customer service points.
Use only original spare. Accidents can arise for the user
through the use of other spare parts. The manufacturer is
not liable for any damage or injury resulting from such ac-
tion.
Description of device
1 Carrying handle
2 Carrying handle with On/Off switch
3 Pendulum cover
4 Saw blade
5 Table insert
6 Locking lever for the rotary table adjustment
7 Locking screw for rotary table
8 Indicator for mitre angle
9 Scale for mitre angle
10 Vise assembly
11 Base plate
12 Support arm
13 Wing nut for vise assembly
14 Scale for incline angle
15 Incline locking lever
16 Indicator for incline angle
17 Stop plate
18 Dust bag
19 Exhaust neck
20 Set screw for the saw blade position
21 Set screw for the cutting depth
22 Protective cover
23 Motor
24 Saw blade locking device
25 Set screw for the pulling device
26 Set screw for 45° saw head incline
27 Set screw for 90° saw head position
28 Battery compartment for laser
29 Work piece stop
30 Set screw for work piece stop
31 Wing screw for support arm
32 Rotary table
33 Laser
A
34 Transport locking pin
35 Carbon brush cover
36 Lock for pendulum cover
37 Carbon brush
38 Hexagonal screw for saw blade mounting
39 Front saw blade flange
40 Rear saw blade flange
41 Spanner
P

Preparing for commissioning

Mounting the locking screw
Insert the locking screw for the rotary table (7) in the larger of
the two holes below the locking lever for the rotary table adjust-
ment.
Tighten the locking screw.
Inserting the batteries
Open the battery compartment (27)
Insert two batteries of the type Micro LR03 (AAA, not in-
cluded) and observe the specified polarity.
Close the battery compartment again (27).
Loosen the transport locking pin before first use and after each
transport:
Slightly push the handle down
Pull out the transport locking pin (34)
To achieve flawless functioning of the machine, please
follow the instructions listed:
Place the machine at a location that meets the following
conditions:
− secured against slipping
− free of vibrations
− even
− free of tripping hazards
− adequate light
To ensure a safe position of the saw it must be bolted down
on a solid surface (e.g. workbench or support frame) at opti-
mal working height:
− Disengage the transport locking pin
−
Make 4 holes in the support matching the holes in the
base plate.
− Bolt the device down.
Before each use, check
− Connection cables for defects (cracks, cuts, etc.)
Do not use any defective cables.
− the saw blade for flawless condition
Do not use deformed or damaged saw blades.
Immediately replace a worn or damaged table insert.
Connect the mitre crosscut saw to a dust collection device
when cutting wood.
22
Q
P
P
B
H
P