Beurer Vital Legs FM 250 Mode D'emploi page 31

Step 3: Switch on the device
• To switch on the EMS circulation stimulator, press the 0 ON/
OFF button on the device or on the remote control. Initially, the
00
intensity level
Step 4: Set the usage time
• Use the button on the device or remote control to select the
usage time you want. You can set a usage time of between 5
and 90 minutes (in 5-minute increments).
Step 5: Start electrostimulation / set the intensity level
• Use the +/- buttons on the device or remote control to select the
intensity level you want for the left foot and the right foot. You can
set an intensity level of between 1 and 99. Press the +/- button
briefl y to set the intensity level, step by step. Press and hold the
+/- button to set the desired intensity level more quickly.
IMPORTANT
get used to the device gradually.
• If it is hard to feel the electrostimulation, you can moisten the
soles of your feet slightly with water. This provides better con-
duction of the electricity. Do not use cream or lotion; only use
water or a water-based electrode gel.
Note
• During electrostimulation, 15 diff erent pulse wave variations run
in a loop for one minute each. To set one of the pulse wave var-
iations permanently, press the M button on the remote control.
If you want the pulse wave variations to be varied again, press
the M button again.
Detection for loss of body contact
• If you take your feet off the foot areas of the EMS circulation
stimulator for less than 5 seconds, the device emits three short
beeps. As soon as you put your feet back on the foot areas, the
intensity level that you previously selected is set again.
• If you take your feet off the foot areas of the EMS circulation
stimulator for more than 5 seconds, the intensity level will reset
to 0. To continue the stimulation, increase the intensity level again
on the EMS circulation stimulator or on the remote control.
is set on the left and the right side.
Start with a low intensity level at fi rst so that you
31