Publicité
1.800.561.8187
F
8
-
Fully grasp the display handle L2
and pass the detector
over a live line (e.g. a cable reel or a chain of lights) from the
feeding point (phase) in direction of the other end of the line.
for continuity is flashing.
-
The point of the cable break has been localized as soon as
M
goes out.
Note:
The cable break detector can be used in earthed mains from
and insulating conditions on site might impair the function.
10. Measuring point illumination
4
-
The measuring point illumination
with the probe tips being open by actuating the push-but-
6
8
ton
of the display handle L2
(1 second).
-
The off automatically after 10 seconds.
-
Do not apply voltage to the device when the battery com-
partment is open!
-
The battery compartment is located on the back of the dis-
8
play handle L2
.
-
Unscrew the screw of the battery compartment cover
and replace the used batteries by two new micro batter-
inserted with correct polarity!
-
Place the battery compartment cover onto the display han-
8
dle L2
and tighten the screw.
12. Technical data
-
nominal frequency range f: 0 to 500 Hz
-
max. indication error: U
n
-
Impedance (internal resistance) of measuring circuit/ load
-
current consumption of measuring circuit: I
-
current consumption of load circuit: I
S
n
n
n
-
parts and protection against solid impurities, dustproof
5 - second index: protected against water jets. The device
can also be used in the rain.
-
max. allowable Duty cycle: 30 s (max. 30 seconds), 240 s
off
-
weight: approx. 250g
-
length of connecting cable: approx. 1,000 mm
-
operating temperature and storage temperature range:
- 15 °C to + 55 °C (climatic category N)
-
times of controlled reduction (thermal protection):
-
response time of the display: 750 ms
13. General maintenance
Clean the exterior of the device with a clean dry cloth.
If there is contamination or deposits in the area of the battery
or the battery housing, clean these areas as well by means
of a dry cloth.
If the device is stored for a longer period of time, remove the
batteries from the device!
14. Environmental protection
Please lead batteries and also the device at the end
of its useful life to the available return and collection
systems
Mode d'emploi
®
DUSPOL
expert 1000
Avant d'utiliser le contrôleur de tension DUSPOL
Lisez le mode d'emploi et tenez impérativement compte des
consignes de sécurité !
Table des matières
1.
Consignes de sécurité
5.
Connexion de charge avec moteur à vibration
6.
7.
Test d'ordre de phases
8.
Test de continuité
9.
Détecteur de rupture de câble
10. Eclairage du point de mesure
11. Remplacement des piles
12. Caractéristiques techniques
13. Entretien général
1.
Consignes de sécurité :
-
Lors de l'utilisation, ne touchez l'appareil qu'aux poignées
www.
.com
02/ 2019
DUSPOL
®
expert 1000
5
M
can be switched on
n
S
n
CAT
®
expert 1000:
information@itm.com
9
Publicité
