Technical Data - Hilti SR 4-A22 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
Battery charge state cannot be indicated while the control switch is pressed and for 5 seconds after
the control switch has been released. If the LEDs of the charge state indicator flash, follow the
instructions in the 'Troubleshooting' section.
3.5
Items supplied
Reciprocating saw, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group | USA: www.hilti.com
4

Technical data

4.1
Reciprocating saw
Rated voltage
Weight in accordance with EPTA Procedure 01 including B22⁄8.0 battery
Stroke rate
Stroke length
Keyless chuck for standard accessory tools
4.2
Battery
Battery operating voltage
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
4.3
Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise information
Sound power level (L
WA
Uncertainty for the sound power level (K
Sound pressure level (L
Uncertainty for the sound pressure level (K
Vibration information
Vibration emission value for sawing chipboard (a
Vibration emission value for sawing wooden beams (a
Uncertainty (K)
6
English
)
)
WA
)
pA
)
pA
)
h,B
)
h,WB
2200413
*2200413*
SR 4-A22
21.6 V
4.4 kg
0 /min ... 3,000 /min
28 mm
1/2 in
21.6 V
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
SR 4-A22
92 dB(A)
3 dB(A)
81 dB(A)
3 dB(A)
SR 4-A22
17 m/s²
20 m/s²
1.5 m/s²

Publicité

Table des Matières
loading

Table des Matières