Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Always disconnect the batteries from the charger after recharging.
Packing and transport
The unit is packaged by the Manufacturer and sent to the dealer in a carton box.
The handling of loads must be carried out in compliance with the current workplace safety rules. Use the box
for storing the tool for medium or long periods or for sending the packed product to a Service Point for repairs.
Tool starting
Before operating the tool, always wear protective clothing.
•
Hold the handle with one hand. With the other one press the ON/OFF button (5).
•
The tool is ready for use.
Use the tool only for the purposes described in par. "Product description". Any other use could cause inju-
•
ries.
Operate the tool only when it is inserted among the branches. Any improper use causes greater tool wear
•
and battery consumption.
5.1.1
Precautions for the use
•
Do not cut either branches with a diameter over 32 mm (STARK M model) or 37 mm (STARL L model), or metals,
stones or any object which is not a plant. When the blades get worn or damaged, replace them.
•
Rinse the shear by means of a clean and dry cloth. Do not use any petrol or solvents.
•
To rinse the shear, do not use abrasive degreasers or containing solvents to rinse the shear.
•
For a proper shear operation follow the instructions. In case of damage do not use the shear, the battery and its
charger.
•
Do not use the shear when it does not work properly.
•
Always remove the battery before any operation of adjustment or parts replacement or before storing it at the end
of the work session. This allows to reduce the residual risks due to an involuntary tool activation.
•
The blades must be closed when the shear does not work.
•
The shear must be operated following the instructions and the way of use indicated in this manual, taking into
consideration the environment and the kind of work to carry out. It is recommended not to use the pruning shears
in case of poor psychophysical skills or in situations which are different from the indicated ones, as it could be very
dangerous.
•
After each use remove the residues from the blades and put the LUBE SPRAY GREASE lubricant recommended
by the Manufacturer. These operations guarantee that the blades are kept in good conditions, reduce wear and
extend the lifespan of the shear as well as of the blades.
Stopping the shear
The shear must be switched off at the end of each work session, therefore:
•
Close the blades
•
Put the ON/OFF button (5) in "off" position
•
Remove the battery
•
Carefully put the shear into its packaging.
5.2.1
Optional metal wire anti-cut function
The shear is equipped with an optional function (which is always disabled on delivery) to avoid accidental cutting of the
vineyard metal wire.
Definition of vineyard metal wire: The term indicates the wire or wires supporting the vegetation and / or shoots of:
•
vineyards with trellis system
•
vineyards with free cordon system
•
vineyards with pergola system / GDC
•
etc.
or of all climbing and non-climbing plants, with single and/all multi-row support or driving wire/s.
ADDITIONAL INFORMATION
The optional function is always disabled in its tool supply configuration.
Use and maintenance manual – Translation of
original Instruction.: 04, Date 22/11/2021
Page 29
Publicité
Chapitres
Table des Matières
Dépannage
