Symbols And Warnings; Tool Starting; Battery Charging - CAMPAGNOLA Stark Manuel D'utilisation Et D'entretien

Symbols and warnings

General warning
Compulsory Use & Maintenance
Manual
Compulsory head protection

Tool starting

• Plug the battery (11) into its seat in the shear body.
• Switch the shear on by means of the ON-OFF button (5). When first using the tool, the display switches on and the
audible alarm emits just one beep.
• Press the trigger two times. The blades will open automatically. In case of failure, the blades will not open. Store the
tool and contact an Authorized Service Point.
• Normal pruning: Press the trigger to close the blades and release it to open them again.
• Blade group closing position: Keep the trigger pressed. 3 long beeps indicate that the shear is in stop position.
• In order to check the shear for proper functioning, before using it, press and release the trigger without carrying out
cuts, to close and open the blades. Repeat the operation more times.
• If not used, the shears will automatically switch off after 5 minutes.
Do not work on trees or stairs, as it is extremely dangerous.
Before starting to work with the tool, wear suitable protective clothing.

Battery charging

Connect the battery (11) to the battery charger (12) (picture 1) and the plug of the charger to the socket (picture 2).
Avoid using electrical extension cables, as they are a source of electrical risks. The battery charger LED light (8)
becomes red while charging. When the battery is charged up, the LED light (8) becomes green.
Use and maintenance manual – Translation of
original Instruction.: 04, Date 22/11/2021
Compulsory adequate clothing
Compulsory hand protection
Compulsory feet protection
Page 27