Start-Up Of The Device/Introduction - AEG MC 4414 CD/MP3 Mode D'emploi & Garantie

Remote Control
1 II PLAY/PAUSE button
2 STOP button
3 I TUNE/UP / I
(reverse search/forward search)
4 MEM DOWN/MEM UP buttons
(down/up album/Radio memory preset)
5 REPEAT button
6 PROG. button
7 INTRO button
8 FUNC. Function selector button
9 MUTE button
10 VOLUME / (volume) buttons
11 FIND/M/S button
12 POWER button
13 BAND button
14 SLEEP button
15 TIMER button
16 EQ button
17 Number buttons

Start-up of the device/Introduction

• Read the operating instructions thoroughly before the start-up!
• Select an appropriate location for the device, e.g. a dry, fl at,
non-slip surface on which the device can be easily operated.
• Make sure that the device is adequately ventilated!
• Connect the loudspeakers to the back of the music centre to
the sockets market „Speaker R and L" (20).
• Insert the plug into a properly installed 230 V, 50 Hz power
socket. Please ensure that the mains voltage corresponds to
the information on the type plate.
• The stored time and stations are lost as soon as the power
supply is interrupted. In order to prevent this, insert the
power reserve batteries into the battery compartment (26)
on the rear of the device.
Inserting the battery/batteries (battery/batteries not supplied)
If there is a power cut or the mains plug has been removed
from the power socket, the settings will be retained if the power
reserve batteries are inserted.
1. Open the battery compartment (26) on the rear of the de-
vice. Insert 2 batteries of type R6 „AA" 1,5 V. Ensure that the
polarity is correct (see the fl oor of the battery compartment)!
2. Close the battery compartment again.
3. If the device is not used for a prolonged period of time,
please take the batteries out in order to prevent leakage of
battery acid.
4. Different battery types or new and used batteries must not
be used together.
CAUTION:
Batteries are not to be disposed of together with domestic
wastes. Dispose of the used batteries at the relevant collection
bin or at your dealer's.
54
05-MC 4414 AEG 54
Do not expose the batteries to high temperatures or direct
sunlight. Never throw batteries into the fi re. There is a danger
/ TUNE/DOWN buttons
of explosion!
Assembling the Feet
If you do not wish to hang up the device on a wall, please attach
the feet as follows:
Setting the Time (in Standby Mode)
1. Keep the PROGRAM button (10/6) held down for approx.
2. Use the UP/NEXT
3. Press the UP/NEXT
4. Press the UP/NEXT
5. Press the PROGRAM button (10/6) again to store the time.
Remote Control Batteries (not supplied)
•
•
•
•
•
WARNING:
(1)
Place the foot as shown into the
holder on the rear of the device or
loudspeakers.
(2)
Now push the foot upwards as
shown until it locks in place.
(3)
The foot has locked in place if you
hear it „click" and the marks are
positioned one above the other (see
illustration).
3 seconds. The words „24 HOUR" appear in the display.
I / BACK/DOWN I
to choose between the 24 hour and 12 hour display. Press
the PROGRAM button (10/6) to confi rm.
NOTE:
The following appears in the case of the 12 hour display
AM = in the morning, PM = in the afternoon/evening.
I / BACK/DOWN I
(8/3) to set the hours. Keep the button pressed down until
the desired hour is reached. Press the PROGRAM button
(10/6) to confi rm.
I / BACK/DOWN I
in order to set the minutes. Keep the button pressed down
until the desired minutes are reached.
Open the lid of the battery compartment on the back of the
remote control.
Insert 2 batteries of type R03 „AAA" 1,5 V. Ensure that the
polarity is correct (see the fl oor of the battery compartment)!
Close the battery compartment again.
If the remote control is not used for a prolonged period,
remove the batteries in order to prevent battery acid leaking.
Different battery types or new and used batteries must not
be used together.
buttons (8/3)
buttons
(8/3) button
01.08.2007, 11:42:03 Uhr