Table des Matières
Publicité
If a clog prevents the normal flow of air to the motor, the thermal protector turns
the motor off automatically to allow the motor to cool in order to prevent
possible damage to the vacuum.
During this time the headlight remains on.
To correct problem, turn off and unplug vacuum, remove clogs and/or
clean/replace filters.
Empty dust bin if necessary.
Wait approximately thirty (30) minutes, plug vacuum in, turn on to see if thermal
protector has reset. Thermal protector will not reset if vacuum is not turned off
even if vacuum cools down.
Thermal Protector
Motor Protector
Automatically opens to provide
cooling air to the motor when a clog
occurs or when dust bag needs
changing.
Motor protector may open when
using tools.
Check operation by placing hand
over end of hose.
If motor protector opens, the vacuum
will make a slightly different sound.
Do not block motor protector.
- 26 -
Publicité
Table des Matières
