Setting / Adjustment; Mains Connection; Chip Extraction - Mafell K 65 cc Traduction De La Notice D'emploi Originale

Table des Matières

Les langues disponibles

- Do not use dull or damaged blades.

Unsharpened or improperly set blades produce

narrow kerf causing excessive friction, blade

binding and kickback.

- Blade depth and bevel adjusting locking levers

must be tight and secure before making the

cut. If blade adjustment shifts while cutting, it may

cause binding and kickback..

- Use extra caution when sawing into existing

walls or other blind areas. The protruding blade

may cut objects that can cause kickback.

Lower guard function

- Check the lower guard for proper closing

before each use. Do not operate the saw if the

lower guard does not move freely and close

instantly. Never clamp or tie the lower guard

into the open position. If the saw is accidentally

dropped, the lower guard may be bent. Raise the

lower guard with the retracting handle and make

sure it moves freely and does not touch the blade

or any other part, in all angles and depths of cut.

- Check the operation of the lower guard spring.

If the guard and the spring are not operating

properly, they must be serviced before use.

Lower guard may operate sluggishly due to

damaged parts, gummy deposits, or a build-up of

debris.

- The lower guard may be retracted manually

only for special cuts such as "plunge cuts" and

"compound cuts". Raise the lower guard by the

retracting handle and as soon as the blade

enters the material, the lower guard must be

released. For all other sawing, the lower guard

should operate automatically.

- Always observe that the lower guard is

covering the blade before placing the saw

down on bench or floor. An unprotected,

coasting blade will cause the saw to walk

backwards, cutting whatever is in its path. Be

aware of the time it takes for the blade to stop after

switch is released.

Riving knife function

- Use the appropriate saw blade for the riving

knife. For the riving knife to function, the body of

the blade must be thinner than the riving knife and

the cutting width of the blade must be wider than

the thickness of the riving knife.

- Adjust the riving knife as described in this

instruction manual. Incorrect spacing, positioning

and alignment can make the riving knife ineffective

in preventing kickback.

- Always use the riving knife except when

plunge cutting. The riving knife must be replaced

after plunge cutting. The riving knife causes

interference during plunge cutting and can create

kickback.

- For the riving knife to work, it must be engaged

in the workpiece. The riving knife is ineffective in

preventing kickback during short cuts.

- Do not operate the saw if the riving knife is

bent Even a light interference can slow the closing

rate of a guard.

Instructions on service and maintenance:

- Regularly cleaning the machine, especially the

adjusting devices and guides, constitutes an

important safety factor.

- Only original MAFELL spare parts and accessories

may be used. Otherwise the manufacturer will not

accept any warranty claims and cannot be held

liable.