AEG AGS1600 Notice D'utilisation page 64

64 www.aeg.com
The appliance operates discon-
tinuously, so the stopping of
compressor does not mean be-
ing no current. That is why you
must not touch the electrical
parts of the appliance before
breaking the circuit.
Problem
The appliance is
noisy
The compressor op-
erates continually
There is too much
frost and ice
It is too warm in the
freezer
Possible cause
The appliance is not sup-
ported properly
The thermostatic control
is set incorrectly
Doors are not shut prop-
erly or do not close tightly
The door has been
opened too frequently
Large quantities of food
to be frozen were put in
at the same time
Food placed in the appli-
ance was too warm
The room temperature is
too high.
Products are not wrapped
properly
Doors are not shut prop-
erly or do not close tightly
The Temperature regula-
tor may be set incorrectly
Temperature regulator
may be set incorrectly
The door does not close
tightly or it is not shut
properly
Large quantities of food
to be frozen were put in
at the same time
Food placed in the appli-
ance was too warm
Solution
Check if the appliance
stands stable (all the four
feet should be on the
floor)
Set a warmer temperature
Check if the doors close
well and the gaskets are
undamaged and clean
Do not leave the door
open longer than necessa-
ry
Wait some hours and then
check the temperature
again
Allow food to cool to room
temperature before stor-
ing
Decrease the room tem-
perature
Wrap the products better
Check if the doors close
well and the gaskets are
undamaged and clean
Set a warmer temperature
Set a lower temperature
Check if the door closes
well and the gasket is un-
damaged and clean
Insert smaller quantities of
food to be frozen at any
one time.
Allow food to cool to room
temperature before stor-
ing.