Sanding Finger; Installation And Setting - Meister MDS260-1 Traduction Du Manuel D'utilisation Original

5456610-Dreiecksch_man 27.04.18 09:12 Seite 39
• Do not leave keys in the machine.
• Observe the general safety notes for
handling electrical tools.
• Switch the device off and pull the
plug out of the socket if the
connection cable is damaged. A
damaged cable must be replaced
by the manufacturer or by their
customer service or a similarly
qualified person.
Safety marks
Pay attention to the safety marks! The
symbols have the following meanings:
Voluntary TÜV "geprüfte
Sicherheit" seal of quality
(tested safety)
CE mark (conformity with
European safety standards)
Do not dispose of with the
household waste!
When carrying out work in
which dust is generated,
wear a face mask and safety
goggles - do not smoke and avoid
naked flames.
Read the operating
instructions!
Double insulated!
7 – Installation and setting
Preselecting the oscillation speed
(Figs. 1 and 2)
The machine is provided with an
electronic control system for
preselecting the oscillation speed
to suit the material. For this, set the
adjusting wheel (1) to a position
between 1 (minimum speed for e.g.
light initial sanding) and 6 (maximum
speed).
For non-binding recommendations for
adjusting the tool, see Fig. 2.
Fitting the sandpaper
CAUTION! Switch off machine.
Pull out the mains plug.
The rubber backing pad is Velcro faced.
This system enables new sandpaper to
be attached quickly and without using a
clamping fixture. Before attaching new
sandpaper, clean the connection link of
the rubber backing pad.
Place sanding sheets tightly over the
sanding pad (6), making sure that the
holes (7) of pad and sandpaper
correspond (fig. 3)
To use the sanding finger (11), loosen
the three retaining screws and remove
the sanding plate (6). Fit sanding finger,
using the three retaining screws (Fig. 4).
Press sandpaper strip firmly onto

sanding finger.

ATTENTION! When the sanding
finger is used, dust extraction
through the sanding plates is not
possible! Therefore always wear a
breathing mask to avoid damaging
your health!
39