Cleaning And Maintenance - IKEA HARMONISK Manuel D'utilisation

ENGLISH
To activate the alarm, disable the
electronic by touching the
3 seconds.
Next, simultaneously touch buttons
C
and for 3 seconds until hearing the
sound signal: at first, only LED 1 will
flash and then both LEDs 1 and 2 will
flash to indicate the activation. Repeat
the procedure to deactivate the alarm:
at first, LED 1 and 2 will flash and
subsequently only LED 1 to indicate
deactivation. If you touch simultaneously
B
buttons and
Cleaning and maintenance
WARNING:
- Never use steam cleaning equipment.
- Disconnect the appliance from the
power supply.
IMPORTANT: do not use corrosive or abrasive
detergents. If any of these products accidentally
comes into contact with the appliance, clean
immediately with a damp cloth.
• Clean the surfaces with a damp cloth.
If it is very dirty, add a few drops of
washing up detergent to the water.
Finish off with a dry cloth.
IMPORTANT: do not use abrasive sponges
or metallic scrapers or scourers. Over time,
these can ruin the surface.
• Use detergents specifically designed for
cleaning the appliance and follow the
manufacturer instructions.
IMPORTANT: clean the filters at least monthly
to remove any oil or grease residuals.
Perimeter suction panel
The suction panel must be cleaned with the
same frequency as the grease filter. Use a
damp cloth and a soft liquid detergent.
Do not use products containing abrasives.
DO NOT USE ALCOHOL
The panel normally covers the grease filters,
A
button for
C
for 1 second you
can verify which filter alarm mode is
activated: LED 1 flashing alone for
grease filter alarm mode, or LEDs 1 and
2 flashing for grease filter and carbon
B
filter alarm mode.
D
HIGH-SPEED BUTTON (suction power).
E
INTENSIVE SPEED BUTTON (suction
power) - duration 5 minutes - touch
again to return to previous setting.
F
LIGHT BUTTON ON/OFF
and must therefore be opened each time
access to the grease filters and the inside
of the hood is required (e.g. to replace the
carbon filters).
Opening: Pull the panel downwards.
Closing: The panels must be fixed to the
appropriate pins on the surface of the hood.
WARNING: Always check that the panel is
fitted properly.
To clean the grease filter
The metal grease filter has an unlimited life
and must be washed once a month by hand
or dishwasher at low temperature and with
a short cycle. With cleaning in a dishwasher
the grease filter may become dull; this does
not effect its filtering capacity.
Grease filter maintenance:
1. Disconnect the hood from the electric
power supply.
2 Remove the grease filters: pull the spring
release handle downwards, then remove
the filter.
3. After cleaning the grease filter, remount
in reverse order ensuring the entire
extraction surface is covered.
The front side is indicated by the writings
"Front" printed on the hidden side of the
panel.
8