Accessories And Spare Parts - ALFRA KFH 150 Notice D'utilisation

Our ALFRA chip lifter, Prod.-No. 18654, is suitable for collecting chips.
Ensure that the unit is switched off during chip removal. Never remove chips with your bare hands.
Risk of injury!
If there has been a build-up of chips inside around the milling cutter, unscrew one of the guide rails.
Never clean the unit with water, flammable liquids or thinners.
10.0 Operation, care and maintenance
The edge deburring unit was designed for workshop use. Experience has shown that the units run
almost uninterruptedly in both continuous and short use. Rough handling and incorrect use of the
machines result in the individual components wearing out faster.
Clean the unit periodically using a normal machine cleaning agent.
Remember that the carbon brushes of the electric motor only have a limited service life and must be
replaced from time to time.

11.0 Accessories and spare parts

Accessories and spare parts KFT 250
High-performance milling motor (spare motor) 1050 Watt
suitable for KFT 250 and KFH 150,
Milling spindle with double ball bearing assembly, steel clamping
flange, standard Ø 43 mm, stepless speed control
Full-wave control electronics with 8 mm chuck and clamping nut
Prod.-No. 25191
Edge milling cutter Type KFT 250 stand model
without motor
incl. 1 set of high-strength special steel guide rails, Chip collecting
container, 1 operating tool set
Prod.-No. 25111
Foot pedal with unit socket (230 V)
Shorter run lines and work that places no strain on the motor.
Prod.-No. 25116
Spare 8 mm chuck
Prod.-No. 25191-50
Clamping nut for 1050 Watt high-performance milling motor
Prod.-No. 25191-51
Spare carbon brushes for 1050 Watt high-performance motor
2 ea. required
Prod.-No. 25191-13
Spare parts only for edge milling cutter KFH 150 hand-guided
Edge milling cutter Type KFH 150
without motor mincl. 1 set of guide rails, 1 set of operating instructions
Prod.-No. 25109
14