Table des Matières
Publicité
26 BedIenunGsAnLeITunG / oPeRATInG InsTRuCTIon / MAnuAL
22
Malfunctions and their removal
Fault
Linearlift doesn´t swivel out
Linearlift doesn´t sink
Linearlift doesn´t raise
Linearlift doesn´t swivel in
Linearlift sinks automatically
slowly
Above mentioned malfunctions can give only a short overview about the multitude possilbe malfunc-
tions. Because of the Lift design it´s not to difficult for the maintenance staff to identify and repair any
other malfunctions. The following points should always be considered:
•
Switch off the electricity
•
Search and repair the cause with consideration.
•
Don´t cause an additional damage throught force
AMF-Bruns GmbH & Co. KG I Hauptstraße 101 I 26689 Apen
Telefon +49 (0) 44 89 / 72 72 -22 I Fax +49 (0) 44 89 / 62 45
Possible cause
1. Handswitch is defect.
2. Battery is empty.
1. Handswitch is defect.
2. Battery is empty.
3. Lowering valve is defekt
1. Handswitch is defect.
2. Battery is empty.
3. Contactor is defekt
1. Handswitch is defect.
2. Battery is empty.
1. Lowering valve does not
close faultlessly
hubmatik@amf-bruns.de
www.amf-bruns.de
Possible remedey
1. Check connections- if necessa-
ry change the switch
2. Charge Battery
1. Check connections- if necessa-
ry change the switch
2. Charge Battery
3. Change lowering valve.
1.Check connections- if necessa-
ry change the switch
2. Charge Battery
3.Change contactor..
1. Check connections- if necessa-
ry change the switch
2. Charge Battery
1. Change lowering valve.
Publicité
Table des Matières
