Installing The Printer Software; Installing The Software In Windows Me, 98, 95, 2000, Or Nt 4.0 - Epson LQ-300+ Démarrage Rapide

4.
Use the Default Setting mode to change the baud rate or parity bit, if necessary.
See "About Your Printer's Default Settings" in chapter 2 of the online User's
Guide.

Installing the Printer Software

After you connect the printer to your computer, you need to install the software included
on the EPSON printer software CD-ROM shipped with your printer.
Your printer software includes:
Printer driver
The printer driver is the software that runs, or "drives," your printer. With it, you
can make printer settings such as print quality, resolution, and paper size.
EPSON Status Monitor 3 utility (Windows Me, 98, 95, 2000, or NT 4.0)
The EPSON Status Monitor 3 utility notifies you of printer errors and displays
printer status information.
EPSON Remote! (a DOS-based printer setup utility)
The EPSON Remote! utility allows you to easily change the printer's default
settings from the computer screen. See "Using the EPSON Remote! Utility" in
chapter 3 of the online User's Guide.

Installing the software in Windows Me, 98, 95, 2000, or NT 4.0

Follow these steps to install the printer software in Windows Me, 98, 95, 2000, or
NT 4.0:
Note:
Installing the printer software for Windows 2000 or NT 4.0 may require
administrator privileges. If you have problems, ask your administrator for more
information.
If you wish to make a floppy disk version of the printer software on your CD-
ROM, insert the CD-ROM and run the START.EXE program. In the dialog box
that appears, click the Driver disk creation utility button and follow the on-
screen instructions.
If you are using the floppy disk version of the EPSON software, make a backup
copy of the EPSON printer software disk or disks before you begin installation.
1.
Make sure that the printer and computer are switched off.
2.
Switch the PC on. Windows starts automatically. Then switch the printer on.
3.
Insert the CD-ROM containing the printer software into the CD-ROM drive. The
AutoPlay function of the CD-ROM drive automatically starts the installation
program on the CD-ROM.
If the installation program does not start automatically, click on Start and then on
Run. In the Run dialog box, enter the drive letter of your CD-ROM drive in the
command line (e.g. E:\), followed by the command START.EXE (e.g.
E:\START.EXE) and click on the OK button.
17