Installing The Product; Connecting External Devices - Epson TM-H6000IV-DT Manuel De L'utilisateur

Masquer les pouces Voir aussi pour TM-H6000IV-DT:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Setup

Installing the Product

Install the product horizontally on a firm, stable surface.
!
CAUTION:
Do not place the product near any magnetic fields to avoid decreasing the MICR
recognition rate.
Q
Note:
The security hook (C1) on the back of the product allows you to attach a commercially
available antitheft wire.

Connecting External Devices

If you connect external devices, connect each cable to the connector on the back of
the product. For the position and shape of each connector, see Illustration B.
!
CAUTION:
When connecting external devices to the USB and powered USB ports, follow the
precautions below.
Confirm the rated current of the external devices by checking the descriptions on
the devices or manuals. Do not use a device whose rated current is unclear.
Connect the external devices only when those total power consumption is 30 W or
less.
When you use powered USB ports, make sure that the TM-H6000IV-DT is turned off
before connecting each cable. When the powered USB mode (See the following
section.) is set to Mode 2, also make sure that the AC cable is disconnected from a
power outlet before connecting it.
Q
Note:
When pulling out the cables whose connectors do not lock themselves (USB cables and
Line-Out cable), pass the cables through the wire saddle (E1) to prevent the cables from
coming off.
Powered USB mode setting
The product has 2 powered USB modes and is initially set to Mode 1.
• Mode 1:
Power is supplied/not supplied for the powered USB ports when the
product power is turned on/off, in accordance with the operation of the
power button.
• Mode 2:
Power is always supplied for the powered USB ports regardless of the
operation of the power button.
To change the powered USB mode setting, follow the steps below. See Illustration F.
1. Make sure that the product is turned off.
2. Remove the 2 screws to remove the cover.
3. Use tweezers to change the position of the switch.
4. Fix the cover with the 2 screws.
TM-H6000IV-DT User's Manual 15
English

Publicité

Table des Matières
loading

Table des Matières