Product Safety Information - Ingersoll Rand IQ V20 Cordless Impactool Manuel D'utilisation

Product Information: Battery Charger

Product Safety Information

Important safety instructions - Save these instructions.
To reduce the risk of fire or electric shock, carefully follow these instructions.
Intended Use:
This Battery Charger is designed for charging Ingersoll Rand batteries only.
●
Only use Ingersoll Rand charger with Ingersoll Rand IQ
may cause battery to burst when charging. Personal injury or property damage may result.
● Charger is not user serviceable. Repair should only be carried out by an Ingersoll Rand Authorized Service Center. User service may result
in electric shock, fire and/or serious personal injury.
●
The BC1120 is a Class A product. In a residential, commercial or light industrial environment it may cause radio interference. This product
is not intended to be installed in a residential environment; in a commercial and light industrial environment with connection to the public mains
supply, the user may be required to take measures to reduce interference.
● This product is not intended to be used by travelers.
For additional information, refer to Battery Charger Safety Information Manual Form 10567832 and Battery Safety Information Manual
Form 10567840.
Manuals can be downloaded from ingersollrandproducts.com
Product Specifications
Model Input
BC1120 100-240V AC ~ 50/60Hz,
BC1121 100W, 160-215VA
Instructions for Charging Battery
The charger shall be installed near a socket-outlet that is easily accessible.
Do not charge battery pack when temperature is below 32°F (0°C) or above 113°F (45°C). Completely charge new battery packs before using. Charg-
ing time is approximately 60-90 minutes.
Unplug charger and remove battery pack when not in use.
Action
Plug charger into 100-240V AC
power outlet.
Insert battery pack into charger.
Remove battery pack.
Legend: ä Flash l On m Off
47514514001_ed3
Series Li-Ion batteries. Use of other batteries or chargers may create a risk of fire or
V20
Output
21V DC (BC1120),
12.6V/21V DC (BC1121), 4.0A
USB Type A, 5V DC, 500mA
D+/D- Connected, 200Ω
Condition
Power On (Stand-By).
Charging.
Fuel gauge will indicate state of charge.
Communications Failure.
Battery Identification / Read Fault
Reinsert battery. Battery may be defective.
Initial Temperature.
Charging paused until battery has returned to safe temperature.
Time Out.
Charge time exceeded. Battery may be defective.
In Cycle Temperature.
Charging paused until battery has returned to safe temperature.
Over Voltage.
High voltage detected. Battery may be defective.
Over Current.
High current detected. Battery may be defective.
Charge Completed.
WARNING
DANGER
WARNING
Model Number Voltage
BL2005
BL2012
BL2010
BL2022
Battery
Rated Capacity
20V 1.5 Ah
20V 2.5 Ah
20V 3.0Ah
20V 5.0 Ah
Charger Display
Alarm
(Sound)
Green Red
-
l m
-
l m
Low ♪ mmmm
m l
Low ♪ mmmm
2 x ä
m
Low ♪ mmmm
3 x ä
m
Low ♪ mmmm
4 x ä
m
Low ♪ mmmm
5 x ä
m
Low ♪ mmmm
m 6 x ä
High
l m
♪ ♪ ♪
EN
Type
Li-Ion
Li-Ion
Li-Ion
Li-Ion
Fuel
Gauge
mmmm
ämmm
Ê
llll
EN-4